![]() Otherwise the the 5.5.5.0 or 6.6.6.0 networks will never make it across to the correct router. Success rate is 100 percent (5/5), round-trip min/avg/max = 0/0/0 msĪlso - as a note - when using RIP, you will need to advertise both 5.5.5.0 and 192.168.1.0. Packet sent with a source address of 6.6.6.6 Sending 5, 100-byte ICMP Echos to 5.5.5.5, timeout is 2 seconds: Packet sent with a source address of 5.5.5.5 Sending 5, 100-byte ICMP Echos to 6.6.6.6, timeout is 2 seconds: Loose, Strict, Record, Timestamp, Verbose: But I am still answering the question.įill out the form & at the Extended commands choose/type Y and enter the source address That address is always 127.0.0.1, and pinging it successfully lets you know that the network adapter on your computer (and the networking software in your OS) is working properly.OK - I know that this is over six years OLD and I know that it is probably answered 100 times elsewhere. If you can't successfully ping your router, but your router appears to be turned on and working, you can try pinging what's known as a loopback address. ![]() Ping your loopback address (127.0.0.1).A successful response lets you know that your local network is working okay, and that the problem reaching the internet location is somewhere out of your control. If you can't successfully ping an internet location, you can then try pinging your router. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |